|
Door Bottom Brush
PVCu |
|
Features |
|
- Tough UPVC carrier
- Nylon brush fibres
- Slot punched carrier
- Easy to fit
- Maintenance Free
- Retaining end caps
|
 |
|
Performance Benefits |
- End caps ensure brush cannot
slip out
- Fixing slots provide
adjustment of fitting to accommodate varying gap sizes
- Core wire and metal crimp rust
protected
- Smooth contour of carrier
makes for easy wipe clean
- Discrete design - blends into
door bottom
|
|
Typical
Applications |
- All exterior door bottoms
- All interior door bottoms
- Accommodates flat floor or raised threshold
|
|
Product
Specification |
- The product is supplied in cut
lengths of 0.914m (3'-0"), or in 0.840m (2'-9") in bundles of
50 pieces with fixing screws and end caps packed with the
product.
- Slots for fixing screws
asymmetrically pitched to ensure a screw is positioned 10mm from
each end when carrier is cut.
- End caps are colour
co-ordinated (clear available to special order)
- Brush fibres supplied at a
standard trim length of 25mm in black nylon. Alternative lengths
can be supplied to special order.
|
|
Part No. |
Length |
Finish |
Style |
| 61418 |
840 |
White |
Straight |
| 61202/914 |
914 |
White |
Straight |
| 61203 |
840 |
Brown |
Straight |
| 61203/914 |
914 |
Brown |
Straight |
| 61237 |
840 |
White |
Angled |
| 61237/914 |
914 |
White |
Angled |
| 61238 |
840 |
Brown |
Angled |
| 61238/914 |
914 |
Brown |
Angled |
|
| |
|
Technical Details |
- The brush insert is made from
high quality nylon type 6, looped over a corrosion free core
wire and crimped into a galvanised steel retainer.
- The carrier is extruded from
impact resistant PVCu. It is designed with curves and slopes to
avoid dust collection, be free from shadow lines and be easily
wiped clean.
- End caps are high impact
polycarbonate.
|
|
Fitting Details |
|
The seal fits at the bottom of the
door, normally on the side that opens inwards. Place the seal at
the bottom of the door and mark off the cut length with Anvil
Secateurs. Cut the brush insert in the same way and crimp the cut
end with pincers to retain the filaments. Slide brush insert back
into carrier and screw in position using fixings and end caps
provided. Position so that filaments lightly rest on floor and
screw home through slots provided. |
|
back to top |
|
technical
specifications page |
|
| |
|
