|
Internal Doorseal
SBx |
|
Features |
|
- Tough PVCu carrier in white or
brown
- Polypropylene pile with double central fin
- Silicone treated pile
- Integral flexible secondary
seal
- Easy to fit
- Flexible integral secondary
seal
|
 |
|
Performance Benefits |
- Easily compressed for ease of
door operation
- Excellent memory and wear
resistance
- Good abrasion resistance in sliding
applications
- Supplied with stainless steel
fixing pins
|
|
Typical
Applications |
- Suitable for sliding, compression or combined
sealing applications.
- All exterior door perimeter seals.
- Al interior door perimeter seals.
- Casement windows.
- Sash windows.
|
|
Product
Specification |
- The product is supplied in cut
lengths of 2.03m (6'-8"), in bundles of 100 pieces with fixing
pins packed with the product. Dooersets, consisting of 2x2.03m
length and 1x101m length are also available to special order.
- Holes for fixing pins are
provided spaced at 125mm (5") centres, and are aligned along the
groove for ease for additional hole drilling.
|
|
Part No. |
Carrier |
|
Style |
Colour |
| 61426 |
SBxII |
White |
|
61427 |
SBxII |
Brown |
|
| |
|
Technical Details |
- Conforms to B.S. 476: Pt 31,
Section 31.1 for cold smoke seals.
- The seal is a woven
polypropylene pile which is sewn into a tough, stable backing
strip. It has a double integral weatherfin for increased sealing
efficiency. The silicone treatment provides low sliding forces
and resists water, mildew and corrosion.
- The carrier is extruded from
impact resistant PVCu smooth design lines and a linear groove
give an appealing, easy clean finish. Extra pins can be driven
straight through the carrier where required.
|
|
Fitting Details |
|
The seal fits on the inside of the
window or door frame, around all edges.
Measure and then cut to length the
piece to fit across the top of the frame to give a neat butt
joined corner.
Offer up to the frame, with the
opener in the closed position, and ensure the pile is in firm
contact with all parts of the frame making approximately 15-20%
compression.
Fix using pins provided.
Measure and cut to length the two
upright pieces and bottom if required to fit in the same manner as
above.
On door frames, the carrier
should be double pinned at the bottom. |
|
|
|
Standards |
|
Compliance
with BS 7386:1990 Class II Product |
|
Parameter |
|
Standard Requirement |
Test Result |
|
A2. Product size and dynamic
characteristics (N) Maximum |
|
60 |
42.8 |
|
A3. Set under sustained
compression (% recovery) Minimum |
-10°C |
55 |
98 |
|
20°C |
55 |
76 |
|
55°C |
55 |
80 |
|
A4. Sliding frictional force
(N/m) Maximum |
L |
20 |
5.6 |
|
T |
20 |
5.0 |
|
A5. Integrity of working
section (N) Minimum |
H |
20 |
35.1 |
|
V |
100 |
114.5 |
|
A7. Air leakage m³/h @ 100Pa
Maximum |
|
7.45 |
0.50 |
|
A8. Resistance to wear (mm)
Maximum |
|
0.50 |
0.38 |
|
|
back to top |
|
technical
specifications page |
|
| |
|
