|
Internal Windowseal
Sc |
|
Features |
|
- Tough UPVC carrier in white
- Polypropylene pile with double
central fin
- Silicone treated pile
- Low closing force required
- Easy to fit
|
 |
|
Performance Benefits |
- Easily compressed for ease of
window operation
- Excellent memory and wear
resistance
- Suitable for all edges of
metal window frames
- Angled design for low closing
forces
|
|
Typical
Applications |
- Suitable for perimeter sealing
of all types of metal window
- For internal use only
- Suitable for gaps 1mm to 5mm
|
|
Product
Specification |
- The product is supplied in cut
lengths of 2.0m (6'-6¾"), in bundles of 100 pieces.
- Design features mechanical
pile retention over entire length
- Inside leg is thin and sprung
to ensure tight grip on frame
- Suitable for wiping,
compression or combined sealing applications.
|
|
Part No. |
Carrier |
|
Pile Height |
Colour |
| 61418 |
8.5mm |
White |
|
| |
|
Technical Details |
- The seal is a woven
polypropylene fibre which is sewn into a tough, stable strip. It
has double integral weatherfin for increased sealing efficiency.
The silicone treatment provides low sliding forces and resists
water, mildew and corrosion.
- The carrier is extruded from
impact resistant UPVC. Smooth design lines
give an appealing, easy clean finish.
- The polypropylene pile is
mechanically fixed to the carrier in a continuous line to ensure
it is securely retained when the product is cut.
|
|
Maintenance and Use |
- Pile seal requires no maintenance other than
periodic cleaning with a damp cloth and household detergents.
- Pile cannot be over painted. Paint splashes
must be immediately removed with a damp cloth.
|
|
Fitting Details |
|
The seal fits on the inside of the
window frame. Open the window and work from the inside. Starting
with the top and bottom edges, measure length, cut and fit then
check window operation. If it does not easily open and close check
for obstructions. On corner adjacent to hinge it may be necessary
to remove a short portion of the inside leg for clearance. Check
window operation. All corner joints should be mitred. For a more
permanent fixing, secure clip-on seal with total seal clear
silicone adhesive (part no 61608) by applying a small bead into
the seal jaws prior to fitment. |
|
Standards |
|
Compliance
with BS 7386:1990 Class II Product |
|
Parameter |
|
Standard Requirement |
Test Result |
|
A2. Product size and dynamic
characteristics (N) Maximum |
|
80 |
46.2 |
|
A3. Set under sustained
compression (% recovery) Minimum |
-10°C |
55 |
93.27 |
|
20°C |
55 |
94.87 |
|
55°C |
55 |
58.30 |
|
A4. Sliding frictional force
(N/m) Maximum |
L |
20 |
6.40 |
|
T |
20 |
6.40 |
|
A5. Integrity of working
section (N) Minimum |
H |
20 |
INTACT |
|
V |
100 |
INTACT |
|
A7. Air leakage m³/h @ 100Pa
Maximum |
|
7.45 |
<0.50 |
|
A8. Resistance to wear (mm)
Maximum |
|
1.00 |
0.27 |
|
|
back to top |
|
technical
specification sheet |
|
| |
|
